close
close

How To Fix A Leaky Bathtub Faucet With One Handle

How To Fix A Leaky Bathtub Faucet With One Handle. Gently pull out the cartridge and. Replacing the washers often fixes the leak.

How to Repair (Not Replace) Your Leaking Bathroom Faucet Dengarden from dengarden.com

If you see a small notch with a hexagonal. Is water leaking out of the handle when you turn the water on? Take pictures, if necessary, and visit your local hardware store for replacement parts.

Gently Pull Out The Cartridge And.

Loosen the screw holding the faucet handle, and remove the handle. Turn the water back on. The most common part that needs replacing to stop a leaky bathroom faucet is the washer, which is at the bottom of the faucet stem.

By Using A Flathead Screwdriver Or Pocket Knife, Just Pop This Cap Off.

Put your faucet back together. Check to make sure the faucet is in the off position and then turn on the water valves under the sink. Remove the retaining clip or nut.

Why Is My Faucet Leaking Under The Handle?

Once the water supply has been shut off, open the faucet to drain all the water still left in the pipe. Use a screwdriver or allen wrench to. Unscrew the set screw to remove the handle.

Take Off The Escutcheon Plate Around The Faucet By Removing The Screws Holding It In Place.

If you can't see one, it must be under a cap,. Look for the set screw that holds the handle to the faucet stem. Shut off the water to the bathtub.

Oil The New Washer And Put It In Place, Then Grease The Packing Nut Screws And Tighten The Packing Nut.

Take pictures, if necessary, and visit your local hardware store for replacement parts. For this type of handle, remove the set screw with a screwdriver and then remove the handle. Put the retainer nut or clip back on to secure the new cartridge or disk in place.

Leave a Reply

Your email address will not be published.